The light incubator is an instrument specially developed by Zhejiang Top Instrument for agricultural research. The light incubator is fully controlled by a microcomputer. The research sets light and temperature for any period of time, provides sufficient sunlight for plant production, and provides equipment for agricultural scientific research. . The light incubator has five sides of the inner wall, some with a plate-shaped heating element, and others with a water jacket. Due to the use of a high-performance thermistor temperature regulator, the incubator maintains a constant temperature with high precision. Water jacket temperature adjustment accuracy is 0.1 degrees. The inner wall of the drainage incubator is made of stainless steel. The plate-shaped heating element is made of two electrodes sandwiched between imm-thick graphite plates to avoid disconnection. Long-term use, the resistance will hardly change. Because the temperature of heat generation is not high, long-term use is not easy to damage. Around the heating element is a soft urethane insulation material with a thickness of 3Omm and a 3Omm thick foamed styrofoam insulation material. The steel plate on the housing shell is sprayed with melamine amine resin paint, and the light incubator has an independent, movable aluminum alloy bracket. The bracket is generally divided into twelve layers. Each layer can be placed in an aluminum tray. The dish can hold dishes. Some equipment, after the removal of the bracket can be installed into a rotating incubator or vibration incubator, connected to the waterproof power socket in the light incubator, you can make dynamic training. The corners of the light incubator are rounded to facilitate cleanliness and disinfection. Scrubbing wastewater can be discharged through the drain valve. There is also a flat plate at the bottom of the light incubator, which can receive drops of water falling from the plate, rack, etc. Permanent magnets are installed around the inner surface of the outer door to keep the door seals as far as possible. The inner door is inlaid with 5mm thick tempered glass. The outer door is also equipped with a plate-shaped heating element over a large area to improve the heat preservation and to avoid the condensation of the inner door glass. Changzhou Golden Oak Rubber Plastic Polymer Co.,Ltd , https://www.czjnsatee.com
August 07, 2024