Stainless Steel Cleat,Stainless Steel Boat Cleats,Stainless Boat Cleats,Stainless Cleat Dongying Highco Metal Manufacturing Co.,Ltd. , https://www.highco-metalcn.com
High temperature solenoid valve features: high temperature, the use of metal seal, improve the use of temperature. Wear: Selection reasonable, the valve cup and guide sleeve clever use of fluid lubrication, reduce wear and tear. High temperature solenoid valve installation: 1, the installation solenoid valve coil up, and maintain the vertical position, the solenoid valve arrow or mark should be consistent with the flow of the pipeline shall not be installed in a splashed water or water leaks 2, the solenoid valve working medium should be clean No particulate impurities, the solenoid valve on the surface of the dirt and filters, to be regularly cleaned. 3, in the solenoid valve failure, in order to isolate the solenoid valve in a timely manner, and to ensure the normal operation of the system, it is best to install the bypass device 4, in the pipeline system, installed in the branch on the solenoid valve diameter should be less than the main pipeline valve The way to. 5, before installing the solenoid valve, the pipeline must be clean. It is advisable to install filters in front of the valve and steam traps to install traps. 6, the valve can not be installed in the pipeline depression, so as to avoid steam condensate, impurities and other precipitation in the valve and impede the action. 7, can not be used in explosive dangerous situations. 8, in the case of inadequate pipeline rigidity, it is recommended to pre-valve pipe with a fixed bracket, so as to avoid vibration caused by the solenoid valve work. 9, before installation, pay attention to see the product signs, read the manual carefully to determine whether the product meets the conditions of use. 10, before and after the solenoid valve to be installed on the pipeline pressure gauge in order to observe the pipeline pressure. High temperature solenoid valve maintenance 1, it is recommended to use the unit to send someone to take charge of maintenance. 2, After the solenoid valve is installed, it needs to pass through the medium experiment several times to confirm the normal condition before putting into formal use. 3, should be regularly cleaned inside and outside the valve and the convergence surface of the dirt, be careful not to damage the sealing surface. 4, Solenoid valve longer time not to be closed before the valve manual valve, re-enable, the steam solenoid valve should be excluded from the condensate clean, and try to move several times until the switch can be used before normal. 5, solenoid valve removed from the pipeline when not in use, the internal and parts should be wiped clean and compressed air blowing net storage. 6, the use of longer time, such as the piston and the seat between the seal is not good, the piston seal surface can be re-polished, and then seat grinding. 7, work, pay attention to the valve before and after the pressure gauge, the working pressure must not exceed the rated pressure, working pressure must be within the rated pressure range. When the working pressure exceeds the rated pressure or working pressure exceeds the rated pressure difference, the solenoid valve to stop using, close the manual valve before and after, so as to avoid the explosion and leakage solenoid valve.
March 19, 2024