Cosmetic preform(11mm - 43mm) Cosmetic Preform(11Mm - 43Mm),Neck Pet Preform,43Mm Neck Pet Preform,Color Cosmetic Preform Heshan Yecheng Plastic Product , https://www.plasticpreform.com
1-inlet pipe; 2-overflow pipe; 3-elastic fastening check nozzle; 4-four-hole equal-resistance bottom discharge sanding port;
5-Single-tube suction-type sand release port; 6-test instrument tube; 7-bag type dust collector; 8--bulk cement feed port;
9-elastic impeller feeder; 10-screw electronic scale; 11- Ñ„ 1.5m mixing drum; 12-funnel grid;
13-barn grid sieve; 14-mixing trench; 15-pin gate; 16-two grid sieve; 17-sink iron nest;
18-mixing tank; 19-150mm water sand filling pipe; 20-100mm cementing filling pipe
The tail silo is a hemispherical vertical sand silo with a diameter of 7m and is made of 14mm thick steel plate. The nozzle is loosely ground with a nozzle, and the long-lived partial fluidization zone is in the range of about 1.3 m in diameter. It is sent to the mixing tank through the suction pipe, and is mixed with the bulk cement to form a cement slurry and sent to the well. The slurry concentration is 75 to 77% and the maximum is 80%. The domestic test adjustment instrument and the single parameter fixed value adjustment system are used to detect and control the filling process (see Figure 1).
FIG 1 Copper Copper Mountain Green filling system schematic diagram
The slag silo has a diameter of 7 m and a slope angle of 35° at the bottom. The slope of the slag has a slope of 20°, and is lined with diabase cast stone and a mixed groove of 300 mm in diameter, which is sent to each stop.
April 29, 2023